Best Stress Distribution Lowest Abrasion Avoid Aging and Flexible Capitally Electric Function
With the same function as common suspension clamps, Helical suspension clamps can be used as suspension conducting wire and earth wire, which not only can effectively protect the conductor but also can reduce the corona discharge,so especially fit for extra high voltage line(220kV or above). In addition, the two support-point type suspension clamps can be applied on tower with big angle(30°-60°)for cross-river long distance transmit electricity. Helical suspension clamps is made up of armor rod, synthetic rubber pad, metallic sheath etc. with arc rubber pad fastening the suspension point, Helical strip binding and fixing conductor, it ensures reliability of operation.
Best Stress Distribution: it distributing the stress conductor bearing to a biggish area, so the static state from cut/pull and bend get small obviously, that develop the conductor’s support, it also can protect conductor when the conductor is waving.
Lowest abrasion: It can support upper unbalanced load, which can avoid the conductor’s slipping.
Avoid Aging and Flexible: Armor-grip is made by the same material as the conductor, meanwhile it has perfect elasticity and tenacity compare to the aluminum, it can avoid aging and flexible, can be used perennially.
Capitally Electric Function: With the end of rod special treated the electric overlight can be protected.
•Armor-grip suspension clamp is intended for use on Aluminum based conductors and galvanized steel strands. It is designed to reduce the static and dynamic stress at the support point, so that the conductor or strand is protected against the effects of oscillations, it also protects the conductor against impulse and power flash-over. Armor-grip suspension is recommended as being superior to armor-clamp combinations, for protecting conductors from bending stress, compression stress and abrasion.
Unbalanced Load: When initially installed, the armor-grip suspension unit has a slip load of approximately 20% of the conductor breaking strength, and approximately 10% of the extra-high standard strands RBS during unbalanced load conditions, but significantly higher loads can be expected after the unit has been in service for a period of time.
Line Angle: The maximum recommended line angle for a single support CL unit is 30°, for angles between 30°and 60°, the CL is recommended.
