1.Brand: Hakko 2.Model:936 3.Antistatic 4.Output Voltage:24V AC 5.Dimensions:120(W) x 93(H) x 70(D)mm
HAKKO 936 Soldering Station
Specification
Name | HAKKO 936 |
Power Consumption | 100, 110, 220-240V / 60W, 120V / 65W |
Part list
Names of parts
Soldering Iron
900S 900S-ESD | 907 907-ESD | 908 908-ESD | |
Power Consumption | 24V AC-50W | ||
Tip to Ground Resistance | Under 2ohm | ||
Tip to Ground Potential | Under 2Mv (TYP 0.6Mv) | ||
Heating Element | Ceramic heater | ||
Cord Assembly | 12.m (4ft) | ||
Total Length(w/o Cord) | 176mm (7in) | 190mm (7.5in) | 200mm (7.9in) |
Weight (w/o Cord) | 25g (0.06Ibs) | 44g (0.09 Ibs) | 54g (0.12Ibs) |
Station
936 Station / 936 Station ESD | |
Output Voltage | 24V AC |
Temperature Rang | 200 – 480°C / 392 – 896°F |
Dimensions | 120(W) x 93(H) x 70(D)mm |
4.7(W) x 3.7(H) X 6.7(D)in | |
Weight (W/O Cord) | 1.300g (2.9Ibs) |
Maintenance
1. Set the temperature to 250°C(482°F)
2. When the temperature stabilizes, clean the tip with the cleaning sponge and check the condition of the tip.
3. If there is black oxide on the solder plated portion of the tip, apply new solder (containing flux) and wipe the tip on the cleaning sponge. Repeat until the oxide is completely removed. Coat with new solder.
4. If the tip is deformed or heavily eroded, replace it with a new one
Calibrating the Iron Temperature
1. Connect the cord assembly plug to the receptacle on the station
2. Set the temperature control knob to 400°C(750°F)
3. Turn the power switch to “ON” and wait until the temperature stabilizes. Remove the CAL potentiometer plug.
4. When the temperature stabilizes, use a straight-edge screwdriver or small plus (+) screwdriver to adjust the screw (marked CAL at the station) until the tip thermometer indicates a temperature of 400°C(750°F). Turn the screw clockwise to increase the temperature and counterclockwise to reduce the temperature. Replace the CAL pot plug.
More picture on HAKKO Tools
Soldering Station Hakko 936
