the 5th generation of waste tyre recycling plant get the great improvement in process time and heating valve .
1.Product name
the 5th generation of waste tyre recycling plant
2.Brief introduction
High efficiency, energy saving, big handling capacity, convenient installation, environment protection … this equipment can make use of waste tyres, plastics, rubbers to refine crude oil, carbon black and steel
3.Raw materials can be used
Waste/Used rubber tyre
Waste industrial mixed plastics,
Waste oil: E.g.: waste diesel oil, engine oil, and other residue oil
Waste cable skin (should first dechlorination treatment)
Waste crude oil and so on.
4.The procedure
Firstly , the raw material was put into furnace,then seal the feed inlet system.
secondly,burned the fuel material(coal,or wood,or natural gas ,oil ) in the combustion system .
the reactor will slowly heat ,when the temperature reach around 250 degree celsius,it will produce oil gas .
oil gas will be processed by our technology ,then gone to cooling system to cold liquid oil.
the gas which can not be liquid under normal pressure ,which will be desinged to back to combustion system to instead the fuel material to burn the reactor .which can save energy very much .
after finished oil produce ,the temperation of reacor will be down ,in same time ,carbon black will be discharged automatically.
Lastely,when the temperature fall to 100 degree celsius,worker could opened the door of reactor to discharge of steel wire .
then can start to another batchworking.
5.The advantages compared with common generation
a.the heating valve will be perseved better than previous technology .which can save running time 4-5 hours .
b.the side discharger will be more clean than before .it without any dust remove and pollution .
6.the picture show below
the 5th generation of waste tyre recycling plant
