Range of the section:

diameter 0,4… 1,2 mm

Diameter on the isolation:

it is maximal 5 mm

The current-response characteristics:

20 A(10 A on each conductor) during not less than 10 min, without the deformation of the module

Note: if is required resistance to the flow of current from 20 A to 30 A, this is ensured by the application of gas-discharge arresters of different types

Insulation resistance

“Dry” atmosphere:

> 10 12 Ohm

“Moist” atmosphere (standard ASTM Of d618, procedure F):

> 10 12[Om]

Salt fog: (standard ASTM Of b117)

> 10 10 Ohm

Immersion beside the water: (15 days before 3% solution Of naCI)

> 10 10 0[m]

The contact resistance

R of material + R of the contact cross connection + by R of the contact connection of the wires

< 10 m

Increase in the contact resistance

After climatic testings:

<2,5 m 

After 50 connections - turning offs:

<2,5 m

Dielectric strength:

>3 kV of direct current during 1 minute

Hullthe material of strengthening the block:

Stainless steel

Heat-shrinkable tubing:

Polyethylene with the adhesive sublayer

Screw of the connection of the distributive wire:

Special alloy Of zamac, [passivirovannyy], with the paint and varnish coat

Housing of the unit of the connection of the distributive wire:

Transparent polycarbonate

Housing:

Polycarbonate, glass-reinforced, resistance to fire “VO”

Fitted contacts: (before the module of connection)

Tinplated phosphor bronze

Contacts of the grounding: (before the module of connection)

Alloy Cu - Zn - Ni - Ag

Contacts of the connection: (before the insertable module)

Tinplated solid bronze

Sealing material before the lower part:

The epoxy resin

Sealing material before the upper cable part:

Silicon compound

Cover of the pair of the distributive wire:

Polycarbonate

Housing of the insertable module:

Polycarbonate, glass-reinforced, resistance to fire “VO”

Sealing material of the insertable module:

Gel

The ring gasket:

Elastomer EPDM

Cable laying is the distributive wire:

Thermoplastic rubber