The equipment adopts the spray tin liquid directly on the solder joint of the through hole component to desolder or solder.
PCB dimension: W400×D400mm
PCB locating way: Jig
Power supply: single-phase 220v, 50/60Hz
Heater: 2000W
Tin volume capacity: 30kgs
Machine dimension: L600×W600×H240
Weight: Appox. 40kgs
------------------------------------------------------------------------------------------------------------------------------
Through hole rework station;
* The equipment adopts the spray tin liquid directly on the solder joint of the through hole
component to desolder or solder;
* A wide large range up to 180 mm of disassemble parts. Install/solder the components in 5
seconds;
* The splint device is easy to operate and can splint the PCB sheet in a large spectrum;
* The upper and lower nozzles are configured to the corresponding component size and align
centre by the upper nozzle;
* It has global and accurate alignment, PCB board can be adjusted to X/Y directions by
accurate alignment;
* Pedal switch controls the solder wave switch, the speed adjusted knob can adjust the
solder wave height continuously. Solder wave time can be set, PCB board and parts are
kept far from harm;
* The equipment has temperature protection. When the solder temperature doesn't reach the
set one, the solder wave doesn't work. This work temperature can be set according to
different conditions with alarm ring and indication light;
* Less solder oxide.
Through Hole Rework Station
