Welding Gun Ignition Pattern: Piezo Ignition Connection Type: Bayonet Type Low Carbon (Enviroment-Friendly) Easy to operate
Product Brief Introduction
| Model No: | JD-8019 | Ignition Pattern: | Piezo Ignition |
| Product Weight: | 133g | Connection Type: | Bayonet type |
| Product Material: | Copper+Aluminum alloy+Stainless steel +Zinc alloy +Plasitc | The maximum flame length | About 200mm |
| Product Size: | 162mm*46mm*66mm | The minimum flame length | About 40mm |
| Product Packaging: | Single-sided blister, Paper Card, Within the box outside the box, 100a/box. | The best flame length | About 170mm |
| Product's Diameter: | 21mm | The flame's size | Thick (Can be adjustable) |
| Product's Clamp Diameter: | 46mm | The flame's form | Concentrate |
| The Best Fuel : | Liquefied butane gas (purity no less than 95%) | The Burning time | About 200 minutes |
Application:
It's suitable for restaurants and household to make food.
Unfreeze meat and water pipe
Picnic
Farming and gardening
Use for the heat-shrinkable sleeves and their connectors
Be applied in microwelding involving copper-welding,sliver-welding,tin-welding and ornament processing.
Fusing,welding,surface treatment and local heating in workshop,garage and lab.
Architetural decoration
Parts of the product:
1.Copper high pressure nozzl,
2.Aluminum alloy Cylinder positioning device
3.Gas regulator(including the switch)
4.Stainless steel's Gun Barrel
Warnings when use this Product:
Mistake use of the product could result in the danger of injury to the user or give rise to the damage of equipment.Gas consumption and heat output were measured and calculated in accordance with in-house testing methodCautions:
1.Some parts will be very hot during and after use,So keep young children away.
2.Change the gas cartridge outside away form sources of heat or naked flame such as pilot lights, electric fires ect and away form other people
3.This appliance should be used away form flammable materials and at least one meter away foem adjacent surfaces (wall,ceiling). Be especially careful near fat fryers, electric hobs and sources of naked flame.
4.Be aware of flaring which may occur during the two minute warm-uo period and in which the appliance should not be angles more than 15 degrees form the vertical (upright) position, And two minutes of running, the appliance is preheated and can be used at any angle without flaring
Maintenance:
Check the appliance is clean and drySeparate the torch from gas canister for your safetyDo not disassemble or re-constructContact dealer,If you have problems
Firepower Armygreen Welding Heating Gun
