1.USB control card EASY-10 2.SINGLE COLRO:32*512 bi-color:32*256, 3.Multi-project;2 pcs of 12 ports;1pcs of 08 ports
USB control card EASY-10
| ITEM | single color dots | bi-color dots | display | interface for single | interface for bi-color | Communication Interface |
| USB control card EASY-10 | 32*512 | 32*256 | multi-project | 2 pcs of 12 ports | 1pcs of 08 ports | USB |
LED display U disk control card user manual
The first step: U disk control card is introduced the interface
As shown with the points: monochrome :32* 512 &16 *1024*
Double color :32*256
EASY-10U disk control card no serial interface, can be directly use U disk to screen for setting parameters and to read the program data.The following will be U disk function to use.
The second step: setting screen.
The control card connected with the screen without the need for good after the data line and computer connection, directly open the software, click on the screen parameter settings, input password"168" into the screen for setting parameters of interface, based on the current use of screen height, width, OE polarity, polarity of data, scanning mode to set the parameters. In a conventional P10 monochrome half outdoor display for example, as shown in Figure.
Adjust the display parameters, click" Settings" to complete the control card screen parameter settings.
Note: screen for setting parameter will appeared in the process of" can't find the control card, please check with your hardware to find " message, this time not ignored, according to the prompts direct click OK on the line.
The third step: editing program ( add program )
Edit the program operation process and conventional control card. As shown in Figure
The fourth step: program data export to U disk ( U disk memory should be in the range 2G ).
Program editing is done, click on the upper left corner of the control software of the file menu to appear " export SD / U disk card format", as shown in Figure
Click the options appear the following tips
Click the drop-down arrow after selecting the current into the computer U disc symbols, after clicking to confirm the data file to the U disk. As shown in Figure
Note: stored in the U disk file format for" led.sd", after saving to open U disk checking for this file.
The fifth step: control card read U disk data
Save the file, the U disk or SD card inserted into the card control interface USB, appeared the following tips
1," read the data, please wait",
2," reading.."
3," reading successfully, please dial card"
The display" please dial card", please remove the U disk or SD card, display screen parameters set up, program is updated, and can display just edit the program.
Note: read U disk data if the screen font display is abnormal or garbled, please refer to the above steps to screen for setting parameters such as operation.
If you don't know the use of display parameters, please consult the display manufacturers, but also to our technical support.
If U disk cannot be read or read after the screen no display, please format the U disk and use it again, or to replace the U disk test.
led display U disk control card
