Electric Nail File & Nail Polish
Electric Nail File & Nail Polish(MY-N308)
Operation:
1. Make sure the appropriate voltage (110V or 220V) is selected by setting the switch at the back of the transformer.
2. Plug in the electric cord of the transformer to the main electric outlet. The lamp on the transformer will turn on.
3. Connect the end of the cord from the hand piece to the front output hole on the transformer, marked handpriece.
4. Turn on the on/off switch on the transformer. (Machine should be at the lowest speed when turning on)
5. Select the desired speed by turning the variable speed control knob on the transformer.
6. The blacks switch in front of the transformer, next to the speed control selection knob is for forward and reverse.
7. To use the foot pedal control, connect the end of the cord from the foot pedal to the output hole at the back of the transformer and press down on the foot pedal.
8. To secure the bits: Push in the desired bit firmly into the hole at the rotating head of the handpriece until the second lock clicks. (Please note the bit has to pass through) two clicks (locks) before it is firmly secured.
9. To remove the bits: Turn off the machine and gently pull the bit out.
Safety Rules:
1. Always unplug the tool when you change accessory or collet.
2. Do not engage the shaft lock button while the tool is running.
3. Do not use near or place in water. If motor falls into water, unplug immediately. Do not reach into water.
4. Do not touch the bit or collet after use. After use, the bit and collet are too hot to be touched by bare hands.
5. Keep dust out of eyes and lungs by using protective eyewear or a dust mask.
6. When not in use, tool must be stored in a dry location and keep out of reach of children.
Technical Parameter:
Voltage: 110V-220V 60Hz/50Hz
Maximum speed: 35,000 RPM
Quantity: 12 pcs
Carton size: 59*49*33.5CM
Gross weight: 17.5kg
Net weight: 15.5kg
MY-N308 Electric Nail File & Nail Polish(CE Approval)
