large waterfall 1)masterial:brush stainless steel and glass 2)easy to install 3)popular for home decoration and room divider
Large stainless steel waterfall series
This artistic water feature blends a contemporary shape with water flowing down glass panels. The panel is clear termped glass while the frame is brush stainless steel, the reservoir is made of stainless steel too, they all very durable in using.
This gardenfall fountain is rated for all weather conditions and can be used indoor or outdorr.
Warning:before fill the water in base fully,the pannel mustn't be placed into the base in case of the pannel falling down.
Frame material: brush stainless steel
panel material:clear tempered glasslight:warm white light
dimesion:A)H90 inchesxW 78inches x D12 inches
B)H90inches X W 96inches X D12 inches
1.Remove all the parts from the shipping cartons.
2.Lean the S/S panel upright against a wall until you further instructed.
3.Remove all the packaging material and parts from the base,which includes the decorative rocks,s/s trays,towel&light kit.
4.Place the piece of sponge onto the base of the fountain and put the pump assembly kit on top of it.NOTE:THIS SPONGE IS USE TO AVOID THE NOISE FROM THE VIBRATING PUMP.
5.Thread and feed the pump cord through the opening provided in the reservoir. Pull the pump cord through the opening leaving approximately 12 inches of the cord inside the reservoir.DO NOT plug the pump into your local power supply.
6.Take the panel with two people;slide the panel into the center of the base .Place a piece of cardboard over the base to prevent it from scratching.It is important to place the panel in the reservoir to the side with the plumbing coming out of the bottom.
7.Once the panel is in place,turn the screws securely into an upright position in the base.
8.Position the hose clamp into position then connect the tube to the PVC pipe coming out from the bottom of the panel.Tighten and secure the hose clamp with a screwdriver.
9.Thread the light cord located on the metal tray through the opening provided in the reservoir.Pull the light cord through the opening and plug the light cord into the transformer.
10.Place the metal tray with light onto the reservoir and arrange the decorative rocks to your liking.
11.Fill the reservoir with water until the water level reaches 1” over the top of the pump.Plug the pump & transformer into your local power supply.
Note:Whereas the light can be submerged as it is an underwater lamp,the transformer for the light CAN NOT BE PUT IN WATER.It must be left outside the reservoir.
flat stainless steel and glass indoor waterfall
