Raspberry Pi Sense Getting Started: Connect your Sense HAT to the Raspberry Pi via the 40 GPIO Pins.You will then need to install the software: Open up a terminal and run the following command: wget -O - http://www.raspberrypi.org/files/astro-pi/astro-pi-install.sh --no-check-certificate | bash (This will take approximately 5 mins to run on the Raspberry Pi 2 Model B, and approximately 20 minutes on earlier models of the Raspberry Pi) When the install has finished you will need to reboot your Raspberry Pi Technical Specification:●Gyroscope – angular rate sensor: +/-245/500/2000dps●Accelerometer - Linear acceleration sensor: +/-2/4/8/16 g●Magnetometer - Magnetic Sensor: +/- 4/8/12/16 gauss●Barometer: 260 – 1260 hPa absolute range (accuracy depends on the temperature and pressure, +/- 0.1 hPa under normal conditions)●Temperature sensor (Temperature accurate to +/- 2 degC in the 0-65 degC range)●Relative Humidity sensor (accurate to +/- 4.5% in the 20-80%rH range, accurate to +/- 0.5 degC in 15-40 degC range)●8x8 LED matrix display●Small 5 button joystick
