Shenzhen MG Technology Co.,Ltd is one of the leading China co2 laser power supply manufacturers and suppliers,Website:http://www.mglasermachine.com, equipped with professional factory we are always able to produce low price co2 laser power supply, dc power supply, 12v power supply, laser power supply with reliable quality.Available power: 40W 60W 80W 100W 150W1. Control terminal wiring instructions1 2 3 4 5 6TH TL WP G IN 5V1)“6” for 5V power supply (not for connected with motherboard, for power adjusting of potentiometer, 5V current is less than 10mA);2)“TL” for high level, “TH” for low level, WP for water protection;3)“4” - G for the ground, “5” for the control input;4)When connected with the control board, light signal connect with “1” when high level lighting (light signal connect “2” when low level lighting), “4” for ground, “5” connected with power control analog signals, “3” and “4” connected;5)“5” can also use PWM, but the peak of pulse should reach 5V, frequency more than 20K;6)When testing: “2” “3” “4” Short circuit (or “3” “4” short circuit, “2” “4” connect with switch), center of the potentiometer connected “5”, other two ends are respectively connected with “4” and “6”);7)High level control switch “1” and “6” connected, “3” and “4” water protection;8)Not suggest to advocate high frequency modulation to control the laser power, it will affect the life of the laser;9)This models suitable for various manufacturers of lasers, but must follow the instructions required of laser tube to regulate the use of current laser;10)Current meter is connected to the negative pole line.2. Power cord wiring instructionsPin 1GroudPin 2 Pin 3AC220V 50Hz 10ANote: 10A for wiring requirements, not actual power consumption.3.Laser connecting line description1) Positive red line with high voltage connected laser tail;2) Negative white line connected laser output.4.Current limitSignal modulation potentiometer do counter clockwise , maximum output current is controlled according to the maximum use of the collocation laser, must limit the working current.5.Linear proportional matching of input signal and output currentAdjusting the signal modulation potentiometer on the bottom side of the power supply, will get different result. Such as: 0-5V corresponds to the output current 0-34mA, or 0-2V corresponding to the output current 0-34mA. Note: do not put excessive potentiometer regulation, otherwise it will lead to the input signal and the actual effect does not match the requirements.6.Use currentOur power use indicators are based on the standard voltage 220V, 50Hz. The input voltage and frequency fluctuation will affect the corresponding power to the working current of the laser. Input voltage instability will accordingly affects the laser output power, as long as the power is provided to the working current of the laser does not exceed the allowable value, then the input voltage fluctuation on laser is had no effect on life span of laser tube.More Spare Parts to buy:Laser Tubes, Laser Power Supply, Water Chillers, Laser Controllers, Laser Motors, Laser Drivers, Laser Focus Lens, Laser Reflective Mirrors, Laser Head, Laser Pulley, Laser Belt, etc.
