HX-SZ100-WP-RGB,Website:http://www.hoionlighting.com, adopt the most advanced PWM (Pulse Width Modulation) digital dimmingtechnology, especially design for RGB led strip. Adopt full touch RF wall panel remote control. 5 functionbuttons and 1 color ring in the center, all buttons are in touch form, the color ring has 64 levels in differentcolor value. Further, there are 9 dynamic modes in the mode button, and the speed is adjustable.Particularly, the wall panel adopts RF wireless technology, and the working voltage is AC90-265V, easyand convenient to install.Especially, HX-SZ100-WP-RGB designed with Synchronization function. It is convenient to useRJ45 connector to connect the multiple controllers together, and achieve the synchronization function ofthousands meters led strips.Technical Parameters:Receiver:Working temperature -20-60℃Supply voltage DC12V~24V0utput 3 channelsConnecting mode common anodeExternal dimension L127*W41*H32 mmPacking size L147*W85*H73 mmNet weight 190gGross weight 220gOutput gray 256 levelsOutput current <6A(each channel)Output power 12V:<216W, 24V:<432WFrequency of RF remote control 433.9MHzRF Wall panel remote control:Working voltage：AC90-265V(50/60Hz)RF signal frequency：433.92MHzTransmission distance：up to 30m（the deviation depend on the environment）Working power：<2WStandby power：<0.2WAmbient temperature：0-45℃Dimension：86*86*40mmPacking dimension: L89*W40*H89mmN.W.:130gG.W: 140gPower and Payload interface:Adopt male and female connector with screw.This product adopts RF full touch control, with one dimming ring and 5 function buttons.The function of each button as below:Important: As RF signal sender, set up the LED Touch faceplate to a RF led driver (RF receiver) beforeuse.1. Press and hold the ¡Mode¡ key before the ¡RF LED Driver¡ powering on, the RF signal light lights red.2. Power up the ¡RF LED Driver¡, and the LEDs will output 50% brightness （Tip: if the output does notoutput 50% brightness， indicating that the code learning is not successful, need to repeat the step 1）.3. Press the ¡ON¡ key, then the LEDs will be 25% brightness.4. Press the ¡Mode¡ key again, then the LEDs will be 5% brightness.5. Press the ¡ON¡ key again，then the LEDs will be 100% brightness，and indicating the successful codelearning. If not, repeat from step 1.Installation Method1) Opening: Gently pry gaps in touch panel with a screwdriver, and remove the panel slowly, asshown below:2）Unplug the connector, connect the power cord, and fix the base part in the 86*86 installation box( user need to prepare the installation box by themselves) on the wall with screws.3）Reconnect the two parts of panel, and cover the face part on the base part to completethe installation.
